Kenmore Freezers Not Cooling Repair in Union City GA

When a Kenmore freezer shows water pooling on floor, the cause is often Door gasket leak causing condensation to run down exterior and pool, Freezer positioned on uneven surface causing water to run to one side and off drain pan, and Refrigerant leak causing surrounding moisture to condense and drip. Our factory-trained Union City technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows freezer over-freezing or too cold, the cause is often Temperature control thermostat stuck in closed position — calling for cooling continuously, Temperature setting accidentally turned to maximum coldest setting, and Electronic temperature sensor sending falsely high (warm) signal — board compensates by over-cooling. Our factory-trained Union City technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows excessive frost buildup, the cause is often Defrost thermostat failed — not signaling heater to turn on, Defrost timer not advancing or stuck in refrigeration mode, and Door gasket torn or improperly seated allowing warm humid air to enter. Our factory-trained Union City technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows door not sealing, the cause is often Freezer not level, causing lid or door to rest at an angle, Heavy overloading causing door frame to distort slightly, and Frost or ice buildup on door gasket preventing full contact. Our factory-trained Union City technicians diagnose and repair using genuine OEM Kenmore parts.