General Electric Freezers Not Cooling Repair in Sandy Springs GA

When a General Electric freezer shows excessive frost buildup, the cause is often Auto-defrost control board malfunction, Defrost heater burned out or open circuit, and Defrost thermostat failed — not signaling heater to turn on. Our experienced Sandy Springs technicians diagnose and repair using genuine parts from authorized distributors.

When a General Electric freezer shows door not sealing, the cause is often Gasket pulled out of mounting channel, Door hinge or lid hinge bent, worn, or out of alignment, and Freezer not level, causing lid or door to rest at an angle. Our experienced Sandy Springs technicians diagnose and repair using genuine parts from authorized distributors.

When a General Electric freezer shows water pooling on floor, the cause is often Drain hose disconnected or kinked preventing water from reaching drain pan, Door gasket leak causing condensation to run down exterior and pool, and Freezer positioned on uneven surface causing water to run to one side and off drain pan. Our experienced Sandy Springs technicians diagnose and repair using genuine parts from authorized distributors.

When a General Electric freezer shows freezer over-freezing or too cold, the cause is often Temperature control thermostat stuck in closed position — calling for cooling continuously, Temperature setting accidentally turned to maximum coldest setting, and Electronic temperature sensor sending falsely high (warm) signal — board compensates by over-cooling. Our experienced Sandy Springs technicians diagnose and repair using genuine parts from authorized distributors.