Expert Dacor Freezers Not Working Repair in Sandy Springs

When a Dacor freezer shows excessive frost buildup, the cause is often Auto-defrost control board malfunction, Defrost heater burned out or open circuit, and Defrost thermostat failed — not signaling heater to turn on. Our factory-trained Sandy Springs technicians diagnose and repair using genuine OEM Dacor parts.

When a Dacor freezer shows door not sealing, the cause is often Gasket pulled out of mounting channel, Door hinge or lid hinge bent, worn, or out of alignment, and Freezer not level, causing lid or door to rest at an angle. Our factory-trained Sandy Springs technicians diagnose and repair using genuine OEM Dacor parts.

When a Dacor freezer shows water pooling on floor, the cause is often Drain hose disconnected or kinked preventing water from reaching drain pan, Door gasket leak causing condensation to run down exterior and pool, and Freezer positioned on uneven surface causing water to run to one side and off drain pan. Our factory-trained Sandy Springs technicians diagnose and repair using genuine OEM Dacor parts.

When a Dacor freezer shows freezer over-freezing or too cold, the cause is often Thermostat calibration drift — set point reading and actual control point separated, Defrost system over-running cooling period — uneven cycle compensation, and Temperature control thermostat stuck in closed position — calling for cooling continuously. Our factory-trained Sandy Springs technicians diagnose and repair using genuine OEM Dacor parts.