Expert Dacor Freezers Not Working Repair in Roswell

When a Dacor freezer shows freezer over-freezing or too cold, the cause is often Electronic temperature sensor sending falsely high (warm) signal — board compensates by over-cooling, Evaporator fan directing excessive cold airflow directly onto stored items, and Thermostat calibration drift — set point reading and actual control point separated. Our factory-trained Roswell technicians diagnose and repair using genuine OEM Dacor parts.

When a Dacor freezer shows excessive frost buildup, the cause is often Auto-defrost control board malfunction, Defrost heater burned out or open circuit, and Defrost thermostat failed — not signaling heater to turn on. Our factory-trained Roswell technicians diagnose and repair using genuine OEM Dacor parts.

When a Dacor freezer shows door not sealing, the cause is often Gasket pulled out of mounting channel, Door hinge or lid hinge bent, worn, or out of alignment, and Freezer not level, causing lid or door to rest at an angle. Our factory-trained Roswell technicians diagnose and repair using genuine OEM Dacor parts.

When a Dacor freezer shows water pooling on floor, the cause is often Drain hose disconnected or kinked preventing water from reaching drain pan, Door gasket leak causing condensation to run down exterior and pool, and Freezer positioned on uneven surface causing water to run to one side and off drain pan. Our factory-trained Roswell technicians diagnose and repair using genuine OEM Dacor parts.