Kenmore Freezers Not Working Repair in Pine Lake GA

When a Kenmore freezer shows water pooling on floor, the cause is often Refrigerant leak causing surrounding moisture to condense and drip, Clogged defrost drain tube diverting meltwater to the floor instead of drain pan, and Drain pan cracked, displaced, or overflowing during defrost cycle. Our factory-trained Pine Lake technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows freezer over-freezing or too cold, the cause is often Electronic temperature sensor sending falsely high (warm) signal — board compensates by over-cooling, Evaporator fan directing excessive cold airflow directly onto stored items, and Thermostat calibration drift — set point reading and actual control point separated. Our factory-trained Pine Lake technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows excessive frost buildup, the cause is often Door gasket torn or improperly seated allowing warm humid air to enter, Lid or door left open frequently or not closing completely, and Drain tube clogged so defrost water cannot exit and refreezes. Our factory-trained Pine Lake technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows door not sealing, the cause is often Frost or ice buildup on door gasket preventing full contact, Food items protruding inside and blocking door from closing completely, and Gasket material hardened or cracked from age and repeated use. Our factory-trained Pine Lake technicians diagnose and repair using genuine OEM Kenmore parts.