Kenmore Freezers Not Cooling Repair in Pine Lake GA

When a Kenmore freezer shows water pooling on floor, the cause is often Drain hose disconnected or kinked preventing water from reaching drain pan, Door gasket leak causing condensation to run down exterior and pool, and Freezer positioned on uneven surface causing water to run to one side and off drain pan. Our factory-trained Pine Lake technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows freezer over-freezing or too cold, the cause is often Thermostat calibration drift — set point reading and actual control point separated, Defrost system over-running cooling period — uneven cycle compensation, and Temperature control thermostat stuck in closed position — calling for cooling continuously. Our factory-trained Pine Lake technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows excessive frost buildup, the cause is often Defrost heater burned out or open circuit, Defrost thermostat failed — not signaling heater to turn on, and Defrost timer not advancing or stuck in refrigeration mode. Our factory-trained Pine Lake technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows door not sealing, the cause is often Door hinge or lid hinge bent, worn, or out of alignment, Freezer not level, causing lid or door to rest at an angle, and Heavy overloading causing door frame to distort slightly. Our factory-trained Pine Lake technicians diagnose and repair using genuine OEM Kenmore parts.