General Electric Cooktops Not Heating Repair in Norcross GA

When a General Electric cooktop shows gas smell near burner, the cause is often Extinguished pilot light allowing raw gas to escape (on older pilot-style cooktops), Thermocouple not closing gas valve after pilot goes out, and Gas valve leaking past its seat when in the off position. Our factory-trained Norcross technicians diagnose and repair using genuine OEM General Electric parts.

When a General Electric cooktop shows control knob or burner selector not working, the cause is often Electronic touch zone controller module failure for that specific zone, Wiring connection from infinite switch to element terminal loose or open, and Knob D-shaft or flat-shaft adapter broken — knob spins without gripping valve stem. Our factory-trained Norcross technicians diagnose and repair using genuine OEM General Electric parts.

When a General Electric cooktop shows burner not heating, the cause is often Blown surface element fuse on glass-ceramic or induction cooktop, Induction coil failure — resonant circuit component failure, and Control board zone output failure. Our factory-trained Norcross technicians diagnose and repair using genuine OEM General Electric parts.

When a General Electric cooktop shows spark igniter clicking constantly, the cause is often Spark module faulty — stuck relay sending continuous power to all igniters, High humidity environment causing surface conductivity on igniter ceramic, and Grounding issue in wiring causing false trigger signal. Our factory-trained Norcross technicians diagnose and repair using genuine OEM General Electric parts.