General Electric Stoves Not Heating Repair in Mableton GA

When a General Electric stove shows pilot light out, the cause is often Thermocouple positioned too far from pilot flame to sense heat, Thermocouple worn out — no longer generating sufficient millivoltage to hold valve open, and Gas pressure fluctuation extinguishing the small pilot flame. Our factory-trained Mableton technicians diagnose and repair using genuine OEM General Electric parts.

When a General Electric stove shows temperature not accurate, the cause is often Sensor probe touching oven wall or rack — false reading, Control board calibration setting changed accidentally, and Convection fan on or off when it shouldn't be — affects perceived temperature. Our factory-trained Mableton technicians diagnose and repair using genuine OEM General Electric parts.

When a General Electric stove shows oven door not closing properly, the cause is often Thermal damage to gasket from prolonged high-temperature use or self-clean cycle, Hinge springs broken or fatigued — no longer holding door in closed position, and Door hinge pin or pivot worn through — door sags and hangs at an angle. Our factory-trained Mableton technicians diagnose and repair using genuine OEM General Electric parts.

When a General Electric stove shows burner not lighting, the cause is often Burner cap off-center or inverted after last cleaning, Thermocouple not sensing the pilot or main flame — closes gas valve, and Spark switch in the knob assembly worn or broken. Our factory-trained Mableton technicians diagnose and repair using genuine OEM General Electric parts.