Samsung Freezers Not Cooling Repair in Kennesaw

When a Samsung freezer shows excessive frost buildup, the cause is often Defrost heater burned out or open circuit, Defrost thermostat failed — not signaling heater to turn on, and Defrost timer not advancing or stuck in refrigeration mode. Our factory-trained Kennesaw technicians diagnose and repair using genuine OEM Samsung parts.

When a Samsung freezer shows door not sealing, the cause is often Door hinge or lid hinge bent, worn, or out of alignment, Freezer not level, causing lid or door to rest at an angle, and Heavy overloading causing door frame to distort slightly. Our factory-trained Kennesaw technicians diagnose and repair using genuine OEM Samsung parts.

When a Samsung freezer shows water pooling on floor, the cause is often Door gasket leak causing condensation to run down exterior and pool, Freezer positioned on uneven surface causing water to run to one side and off drain pan, and Refrigerant leak causing surrounding moisture to condense and drip. Our factory-trained Kennesaw technicians diagnose and repair using genuine OEM Samsung parts.

When a Samsung freezer shows freezer over-freezing or too cold, the cause is often Temperature control thermostat stuck in closed position — calling for cooling continuously, Temperature setting accidentally turned to maximum coldest setting, and Electronic temperature sensor sending falsely high (warm) signal — board compensates by over-cooling. Our factory-trained Kennesaw technicians diagnose and repair using genuine OEM Samsung parts.