Expert JennAir Freezers Not Working Repair in East Point

When a JennAir freezer shows water pooling on floor, the cause is often Door gasket leak causing condensation to run down exterior and pool, Freezer positioned on uneven surface causing water to run to one side and off drain pan, and Refrigerant leak causing surrounding moisture to condense and drip. Our factory-trained East Point technicians diagnose and repair using genuine OEM JennAir parts.

When a JennAir freezer shows freezer over-freezing or too cold, the cause is often Temperature control thermostat stuck in closed position — calling for cooling continuously, Temperature setting accidentally turned to maximum coldest setting, and Electronic temperature sensor sending falsely high (warm) signal — board compensates by over-cooling. Our factory-trained East Point technicians diagnose and repair using genuine OEM JennAir parts.

When a JennAir freezer shows excessive frost buildup, the cause is often Defrost thermostat failed — not signaling heater to turn on, Defrost timer not advancing or stuck in refrigeration mode, and Door gasket torn or improperly seated allowing warm humid air to enter. Our factory-trained East Point technicians diagnose and repair using genuine OEM JennAir parts.

When a JennAir freezer shows door not sealing, the cause is often Freezer not level, causing lid or door to rest at an angle, Heavy overloading causing door frame to distort slightly, and Frost or ice buildup on door gasket preventing full contact. Our factory-trained East Point technicians diagnose and repair using genuine OEM JennAir parts.