General Electric Freezers Not Working Repair in East Point GA

When a General Electric freezer shows water pooling on floor, the cause is often Door gasket leak causing condensation to run down exterior and pool, Freezer positioned on uneven surface causing water to run to one side and off drain pan, and Refrigerant leak causing surrounding moisture to condense and drip. Our experienced East Point technicians diagnose and repair using genuine parts from authorized distributors.

When a General Electric freezer shows freezer over-freezing or too cold, the cause is often Temperature control thermostat stuck in closed position — calling for cooling continuously, Temperature setting accidentally turned to maximum coldest setting, and Electronic temperature sensor sending falsely high (warm) signal — board compensates by over-cooling. Our experienced East Point technicians diagnose and repair using genuine parts from authorized distributors.

When a General Electric freezer shows excessive frost buildup, the cause is often Defrost thermostat failed — not signaling heater to turn on, Defrost timer not advancing or stuck in refrigeration mode, and Door gasket torn or improperly seated allowing warm humid air to enter. Our experienced East Point technicians diagnose and repair using genuine parts from authorized distributors.

When a General Electric freezer shows door not sealing, the cause is often Freezer not level, causing lid or door to rest at an angle, Heavy overloading causing door frame to distort slightly, and Frost or ice buildup on door gasket preventing full contact. Our experienced East Point technicians diagnose and repair using genuine parts from authorized distributors.