Expert JennAir Freezers Not Cooling Repair in Duluth

When a JennAir freezer shows door not sealing, the cause is often Food items protruding inside and blocking door from closing completely, Gasket material hardened or cracked from age and repeated use, and Gasket pulled out of mounting channel. Our factory-trained Duluth technicians diagnose and repair using genuine OEM JennAir parts.

When a JennAir freezer shows water pooling on floor, the cause is often Drain pan cracked, displaced, or overflowing during defrost cycle, Drain plug on chest freezer removed, cracked, or not seated properly, and Drain hose disconnected or kinked preventing water from reaching drain pan. Our factory-trained Duluth technicians diagnose and repair using genuine OEM JennAir parts.

When a JennAir freezer shows freezer over-freezing or too cold, the cause is often Electronic temperature sensor sending falsely high (warm) signal — board compensates by over-cooling, Evaporator fan directing excessive cold airflow directly onto stored items, and Thermostat calibration drift — set point reading and actual control point separated. Our factory-trained Duluth technicians diagnose and repair using genuine OEM JennAir parts.

When a JennAir freezer shows excessive frost buildup, the cause is often Drain tube clogged so defrost water cannot exit and refreezes, Auto-defrost control board malfunction, and Defrost heater burned out or open circuit. Our factory-trained Duluth technicians diagnose and repair using genuine OEM JennAir parts.