Kenmore Stoves Not Heating Repair in Cumming GA

When a Kenmore stove shows burner not lighting, the cause is often Igniter tip blocked with food spillover, grease, or crumbs, Burner cap off-center or inverted after last cleaning, and Thermocouple not sensing the pilot or main flame — closes gas valve. Our factory-trained Cumming technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore stove shows pilot light out, the cause is often Thermocouple positioned too far from pilot flame to sense heat, Thermocouple worn out — no longer generating sufficient millivoltage to hold valve open, and Gas pressure fluctuation extinguishing the small pilot flame. Our factory-trained Cumming technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore stove shows temperature not accurate, the cause is often Sensor probe touching oven wall or rack — false reading, Control board calibration setting changed accidentally, and Convection fan on or off when it shouldn't be — affects perceived temperature. Our factory-trained Cumming technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore stove shows oven door not closing properly, the cause is often Thermal damage to gasket from prolonged high-temperature use or self-clean cycle, Hinge springs broken or fatigued — no longer holding door in closed position, and Door hinge pin or pivot worn through — door sags and hangs at an angle. Our factory-trained Cumming technicians diagnose and repair using genuine OEM Kenmore parts.