Kenmore Freezers Not Working Repair in Austell GA

When a Kenmore freezer shows door not sealing, the cause is often Door hinge or lid hinge bent, worn, or out of alignment, Freezer not level, causing lid or door to rest at an angle, and Heavy overloading causing door frame to distort slightly. Our factory-trained Austell technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows water pooling on floor, the cause is often Door gasket leak causing condensation to run down exterior and pool, Freezer positioned on uneven surface causing water to run to one side and off drain pan, and Refrigerant leak causing surrounding moisture to condense and drip. Our factory-trained Austell technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows freezer over-freezing or too cold, the cause is often Thermostat calibration drift — set point reading and actual control point separated, Defrost system over-running cooling period — uneven cycle compensation, and Temperature control thermostat stuck in closed position — calling for cooling continuously. Our factory-trained Austell technicians diagnose and repair using genuine OEM Kenmore parts.

When a Kenmore freezer shows excessive frost buildup, the cause is often Defrost thermostat failed — not signaling heater to turn on, Defrost timer not advancing or stuck in refrigeration mode, and Door gasket torn or improperly seated allowing warm humid air to enter. Our factory-trained Austell technicians diagnose and repair using genuine OEM Kenmore parts.